Spot smoke where ceiling detectors are slow to react.
In a tall warehouse or an open yard, smoke can spread sideways for a long time before it reaches a ceiling detector. A camera looking at the area can see it much sooner.
AI fire and smoke detection analyses CCTV video to recognise visible smoke and flame and alert people immediately. It is most useful in large, high-ceiling or open areas such as warehouses, yards and process halls, where smoke can take time to reach a conventional detector. PredCo runs it on your existing cameras as an additional early-warning layer, not as a replacement for your fire alarm system.
What it detects on your floor.
Configured per zone and per shift, on the cameras already pointed at the area.
Visible smoke
Rising or drifting smoke in the camera view, including in large open halls.
Open flame
Flames at storage, scrap, electrical panels and process areas.
Hot-work areas
Extra attention where welding and cutting happen near combustible material.
Blocked exits and fire equipment
Pallets or material in front of exits, extinguishers and hydrant points.
After-hours events
Nights and holidays, when fewer people are around to notice.
Evidence clip with every alert
The responder sees what the camera saw before they get there.
- High-bay warehouses
- Scrap yards and outdoor storage
- Paint shops, chemical stores and solvent areas
- Electrical rooms and panel areas
- Construction sites
Four steps, on hardware you already own.
- 1
Use the cameras you have
Any RTSP or ONVIF feed becomes a sensor. No replacement cameras and no new cabling.
- 2
Detect at the edge
A GPU unit inside the plant runs the models. Footage stays on site and faces are blurred before frames leave the GPU.
- 3
Alert whoever can act
Zone-specific alerts reach the supervisor on Teams, SMS, email or your EHS system in under a second.
- 4
Fix the pattern, not the event
A daily summary by zone and shift shows where and when unsafe acts repeat, so supervisors fix the cause before it turns into an injury.
PredCo watches and alerts people. It does not stop machines and it is not a safety-rated system, so it never replaces guarding, interlocks or your safety procedures. It makes sure the people responsible see what the cameras see.
Free 7-day CCTV safety snapshot
We connect PredCo to two to four of your existing cameras for seven days and send you a written report of what they saw: PPE misses, people in forklift lanes and restricted zones, smoke, and blocked exits, with timestamps and clips. Footage stays inside your plant.
- Pick 2–4 cameras. The zones you worry about most. Any RTSP or ONVIF camera works, including Hikvision, CP Plus, Dahua, Axis and Bosch.
- We connect on site. Inference runs on an edge unit inside your network. No footage leaves the plant, and faces are blurred before anything is stored.
- Seven days of detection. Every shift, including nights and weekends, because that is where supervision is thinnest.
- A written report. Events by zone, shift and type, with clips. Yours to keep, whatever you decide next.
- Manufacturing plants, warehouses and construction sites in India
- At least a few working CCTV cameras over the production or yard area
- Someone from EHS, operations or the plant team to point us at the right cameras
Other jobs for the same cameras
Questions plant teams ask.
Bring one problem. We'll show you the deployment.
A 30-minute working session with our engineering team. No slideware. Bring a real operational problem and leave with a concrete view of what a PredCo deployment looks like for your plant.